Clog
A clog occurs when the hotend or the extruder gets clogged with filament and other debris.2024/07/16 20:08
Model Warping, Falling Off, or Collapsing
Warping, falling off, or collapsing during printing is usually caused by shrinkage and insufficient adhesion to the build plate.2024/07/16 20:08
Different Areas of the Model Have Different Gloss
The filament's surface can change from shiny to matte during printing due to factors like temperature, speed, layer height, minimal layer time, and cooling.2024/07/16 20:08
First Layer not Sticking to the Plate
This wiki article presents an example of the first layer not sticking correctly and solutions to this issue.2024/07/16 20:08
Under Extrusion
This is usually caused by insufficient extrusion, resulting in two phenomena: overall under-extrusion and local under-extrusion.2024/07/16 20:08
Printed Model Warping
This wiki article presents an example of a warped model and solutions to this issue.2024/07/16 20:08
Overheated Layers, Droopy Prints
This wiki article presents an example of overheated layers and solutions to this issue. 2024/07/16 20:08
Inconsistent Adhesion on Plate
This wiki article presents an example of adhesion issues and solutions to solve this problem. 2024/07/16 20:08
Gaps /Inconsistency of the Top Layer
This wiki article presents a few examples of inconsistent top layers and solutions to this issue. 2024/07/16 20:08
Layer Shifts
This wiki article presents an example of a layer shift and solutions to this issue2024/07/16 20:08
Lines not Connected to Printed Walls
This wiki article presents an example of printed lines not connected to the walls and solutions to this issue.2024/07/16 20:08
Dots on the Printed Model Walls
This wiki article presents an example of dots on the printed model walls and solutions to this issue.2024/07/16 20:08
Model Interlayer Cracking
Interlayer cracking happens when the bonding between printed layers is weak, resulting in the layers disconnecting. 2024/07/16 20:08
The Filament Sticks to the Nozzle
A small amount of filament sticks to the nozzle, causing material shortages, roughness, and other issues in the printed model.2024/07/16 20:08
Bad Overhang
When printing overhangs, the extruded filament may not cool in time and bond properly, causing it to droop.2024/07/16 20:08
Bad Bridging
Poor bridging quality occurs when the extruded filament does not bridge smoothly.2024/07/16 20:08
Stringing and Oozing
Excessive nozzle extrusion or abnormal molten filament flow.2024/07/16 20:08
Seam
In FDM 3D printing, a seam is formed at the junction of the starting and end points of each layer of printing, which is a normal phenomenon.2024/07/16 20:08